Troubleshooting - Champion IUH 351 Instalación Y Operación, Manual De Servicio Y Partes De Reemplazo

Follow the troubleshooting guide below in the event that your dishwasher does not operate as
expected. Perform the basic checks below before calling an authorized service agent:
1. Make sure that the main water supply is turned on.
2. Make sure that the main power is turned on.
Make sure that the flexible water fill and drain hoses are not kinked.
3.
Condition
Dishwasher will not run.
Low or no water.
Chemicals won't feed into
dishwasher.
Poor wash results.
Dishwasher stays in
wash cycle.
Cause
Door not closed.
Main power OFF.
Dishwasher OFF.
Main water supply off.
PRV setting incorrect
Solenoid strainer clogged.
Solenoid valve defective.
Chemical supply low.
Pick-up tube clogged
Supply tubing damaged.
Supply tubing kinked.
Wares incorrectly loaded.
in dishrack.
Clogged sump filter.
Clogged spray arms.
Detergent injector not
feeding.
Thermostat defective.
Detergent motor defective.
Water temperature low.
Safe-T-Temp extends wash
mode to allow final rinse
water booster temperature
to reach 180˚F/82˚C.
Dishwasher is operating in
the Extended Wash Mode.

Troubleshooting

Troubleshooting
Solution
Close door completely.
Check breaker on panel.
Turn dishwasher ON.
Open supply valve.
Adjust the PRV setting
Clean strainer.
Contact Service Agent.
Refill chemical container.
Clean/replace tube.
Replace tubing.
Straighten tubing.
Reposition wares or
reduce amount of wares.
Clean sump filter.
Clean spray arms.
Replace squeeze tube or
clean tubing and pick-up
tube.
Contact Service Agent.
Contact Service Agent
Drain and refill wash tank
and run 2 empty cycles.
Contact service agent if
problem persists.
Contact Service Agent
because booster
thermostat is defective.
Press the Extended Wash
button 1 time. The Extended
Wash Indicator light will go
out, the wash cycle will
resume where it left off and
perform a final rinse cycle.
13