Installing The I625Ptz Recessed Indoor Flush Mount Housing - American Dynamics i625PTZ Guía De Referencia Rápida

English i625PTZ Recessed Indoor Flush Mount Housing Quick Reference Guide

Installing the i625PTZ Recessed Indoor Flush Mount Housing

The following describes the installation procedure for the i625PTZ Recessed Indoor Flush Mount
Housing.
Step Action
1 Remove the recessed indoor flush mount unit from the packaging.
2 Using the template supplied, as illustrated in Figure 1:
a Determine the direction of the cable routing and orientate the template.
Note
The housing has a conduit adapter, this will determine the orientation of the
template.
b Drill two 20mm diameter holes in the positions highlighted on the template. See
diagram below.
c Use one of the drilled holes for the saw entry and cut around the profile.
Drill 20mm
hole here
2
Figure 1
Cut Line
i625PTZ Indoor Recessed Housing
Drill 20mm
hole here