Raise Support Legs Automatically - AL-KO UP4 Manual De Instrucciones

en
6. Push slider switch (2G) on the remote control to "OFF" (0).
Green LED (2I) on the remote control goes out.
7. Store the remote control in a safe place (out of the reach of children or unauthorised persons).
8. Turn off battery disconnection switch (1).

Raise support legs automatically

ADVICE
Before using the system, the handbrake must be applied and the jockey wheel lowered onto
solid ground and locked!
1. Turn on battery disconnection switch (1).
2. Push slider switch (2G) on the remote control to "ON" (I).
Green LED (2I) on the remote control has a steady light. The system is ready for operation.
3. Press function selection button (2D) to select "Support system mode".
An acoustic signal sounds.
In "Support system" mode, green control LED (2E) lights up.
4. Hold both automatic lower buttons (2J and 2Q) pressed simultaneously for at least 3 seconds.
Blue "Automatic function" LED (2P) flashes and an acoustic signal sounds once a second until
the automatic function starts.
5. After 3 seconds, release automatic buttons (2J and 2Q).
The support leg pairs (first front, then rear) are completely raised automatically.
Blue "Automatic function" LED (2P) has a steady light.
WARNING!
Risk of injury!
The automatic function can be interrupted by pressing any other button!
When all the support legs have been completely lowered, an acoustic signal sounds.
Deactivate the AL-KO support system after use:
1. Push slider switch (2G) on the remote control to "OFF" (0).
Green LED (2I) on the remote control goes out.
2. Store the remote control in a safe place (out of the reach of children or unauthorised persons).
3. Turn off battery disconnection switch (1).
WARNING!
Risk of accidents!
Before starting the journey, check that each individual support leg is fully raised!
34
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 34
1659595_a
08.11.2017 11:19:34