Adjusting Support Legs Manually - AL-KO UP4 Manual De Instrucciones

Adjusting support legs manually

It is assumed that the battery disconnection switch and the remote control are switched on.
Lowering support legs manually
1. Press lower button (2S).
Red LED (2R) has a steady light.
ADVICE
The buttons for the individual support legs have no function as long as the lower button is
not activated.
If no other button is pressed within 30 seconds, red LED (2R) goes out and the function
is deactivated again.
2. Now press one of the following buttons to lower the corresponding support leg:
Button Support leg
2F Support leg front right (3C)
2H Support leg rear right (3D)
ADVICE
Two buttons and hence two support legs can be actuated at the same time.
The motors of the support legs stop if the contact pressure between chassis and ground becomes
too high.
CAUTION!
Possible damage to the caravan!
Do not use the support system for jacking up or lifting the caravan!
CAUTION!
Different caravan chassis and caravan floors differ in their characteristics and designs. Impru-
dent use of the function for the individual support legs can result in damage to the caravan
chassis or caravan floor. The setting of the lifting load is designed to protect the motor and the
control unit, but it does not protect your caravan or its chassis from damage.
Raising support legs manually
1. Press raise button (2A).
Red LED (2B) has a steady light.
ADVICE
The buttons for the individual support legs have no function as long as the raise button is
not activated.
If no other button is pressed within 30 seconds, red LED (2B) goes out and the function is
deactivated again.
2. Now press one of the following buttons to raise the corresponding support leg:
Button Support leg
2F Support leg front right (3C)
2H Support leg rear right (3D)
ADVICE
Two buttons and hence two support legs can be actuated at the same time.
1659595_a
1659595_a BA UP4 El_Caravanstütze ESS1 DIN A5 sw.pdf 35
Button Support leg
2T Support leg rear left (3B)
2U Support leg front left (3A)
Button Support leg
2T Support leg rear left (3B)
2U Support leg front left (3A)
en
35
08.11.2017 11:19:34