Connections - Denon DRR-M33 Instrucciones De Operación

4

CONNECTIONS

Connecting to the RCD-M33/M35DAB
2 When connecting to a receiver other than the one
in the RCD-M33/M35DAB there is no need to make
connection 3. Note that in this case none of the
system functions (auto power on, etc.) will work.
• System operations such as the auto power on
function can only be used if stereo audio cords and
system cords are connected between all the
system components. Be sure to securely connect
all the connection cords between all the units.
• Disconnecting a system cord during system
operation may result in malfunction. Be sure to
unplug the power supply cords before changing the
connections.
• Install the components in such a way that the
ventilation holes of the CD receiver (RCD-
M33/M35DAB) are not obstructed.
• Use the AC OUTLET for audio equipment only.
Do not use them for hair driers, etc.
2
CD receiver (RCD-M33/M35DAB)
(option)
[Side by side installation]
DRR-M33
Install the sets as shown in one of these
diagrams. In either case, be sure that the CD
receiver's ventilation holes are not obstructed.
The illustration of the CD receiver in the diagram or the operation description is for the RCD-M33/M35DAB.
1
3
1
2
RCD-M33/M35DAB
3
[Stacking installation]
4
RCD-M33
/M35DAB
DRR-M33
Recommended System Installation
• Do not place another component directly on top of the CD
receiver (RCD-M33/M35DAB).
• To ensure stability, do not stack more than two units.
NOTES:
• Do not plug power supply cords into power outlets until all
• Check the left and right channels and be sure to
• Plug in the power supply cords securely.
4
• Clasping the power supply cords and connection cords
• After unplugging the power supply cord, wait at least 5
Cassette deck
(DRR-M33)
Power plug
(for U.K. model)
Connect the DRR-M33's LINE OUT terminals to the CD
receiver's TAPE IN terminals using the included stereo
audio cord.
Connect the DRR-M33's LINE IN terminals to the CD
receiver's TAPE OUT terminals using the included stereo
audio cord.
Connect the DRR-M33's SYSTEM CONNECTOR terminal
to the SYSTEM CONNECTOR terminal on the CD receiver
(RCD-M33/M35DAB) using the included system cord.
Connect this unit's power supply cord to the AC outlet on
the CD receiver (RCD-M33/M35DAB) .
The DRR-M33 can also be used when connected to a
receiver other than the RCD-M33/M35DAB. In this case,
none of the system functions (auto power on, etc.) will work.
Some receivers other than the RCD-M33/M35DAB are
equipped for connections of two or more cassette deck's,
allowing tapes to be copied. Read your receiver's operating
instructions carefully before using it.
connections have been completed.
interconnect them correctly (R to R, L to L).
Incomplete connections will result in noise.
together may result in humming or noise.
seconds before plugging it back in.
Power plug
AC 230 V, 50 Hz
(Plug into a power outlet)
ENGLISH
5