Mr. Heater MH25NG Instrucciones De Funcionamiento Y Manual Del Propietario página 12

CHAPTER IV
OPERATOR MAINTENANCE
INSTRUCTIONS
1. TROUBLESHOOTING
A. Table 4 lists the common malfunctions which you
may find during the operation or maintenance of your
heater.
B. For additional information, refer to Honeywell Field
Bulletin enclosed in the heater carton.
C. In the event results cannot be obtained after
performing all listed solutions, call the factory.
2. ADJUSTING THE PILOT FLAME
The pilot flame should envelop 3/8 to 1/2 in. (10 to
13 mm) of the tip of the thermocouple or generator.
Refer to Figure 11. To adjust:
CONTROL KNOB
WRENCH
BOSS
GAS
INLET
PILOTSTAT POW-
ER UNIT
PRESSURE REGULATOR ADJUSTMENT
MANUAL GAS
PILOT FLOW ADJUSTING SCREW
(BENEATH COVER SCREW)
Figure 12. Top View of Standard Capacity Gas Control
PROPER FLAME
ADJUSTMENT
Figure 11. Proper Flame Adjustment
A. Remove pilot adjustment cover screw. Refer to
Figure 12.
B. Turn inner adjustment screw clockwise
decrease or counterclockwise
pilot flame.
C. Always replace cover screw after adjustment and
tighten firmly to ensure proper operation.
(BENEATH COVER SCREW)
STANDARD
PRESSURE
REGULATOR
("A" MODEL)
STEP OPENING REGULATOR
PILOT GAS OUTLET
(PRESSURE TAPPING
DIRECTLY BENEATH)
Installation instructions and Owner's Manual
E12
3/8 TO 1/2 INCH
(10-13 MILLIMETERS)
THERMOCOUPLE
to increase
INSTALL LONG
SCREW IN
OUTSIDE CORNER
("C" MODEL)
to