Add Engine Oil - Generac OneWASH Power Washer Manual Del Operador

4. Install hose hook (Figure 4-4).
Figure 4-4. Install Hose Hook
5. Insert color–colored nozzles in spaces provided in
front panel (Figure 4-5).
Figure 4-5. Insert Nozzles
6. Place spray gun/lance extension onto spray gun
holder as shown (Figure 4-6).
Figure 4-6. Gun/Lance
12
7. Place recoil rope into holder as shown (Figure 4-7).
Figure 4-7. Recoil Rope Hook
8. Attach siphon tube to location A (Figure 4-8).
A
Figure 4-8. Siphon Tube Location
4.2 — A E
DD NGINE
1. Place power washer on a flat, level surface.
2. Clean area around oil fill and remove orange oil fill
cap/dipstick.
3. Using oil funnel, slowly pour oil into fill opening. See
"Maintenance" section for oil type recommendation.
On some units there is more than one oil fill location.
In these instances it is only necessary to use one of
the oil fill points.
4. Check periodically until the oil level is between "L"
and "H" on the dipstick (Figure 4-9). Do not overfill.
O
IL
NOTE:
OneWASH™ Power Washer
Set-up