Victron energy Victron Global Remote Manual página 11

4. Configuring the VGR
All configuration is performed by sending commands to the VGR via SMS.
4.1 SMS Alerts
To enable SMS alerts, send the following command from the number which should receive the
alerts:
alert on
Note: If alerts were previously configured to be sent to another number, that number will no
longer receive alerts.
To disable SMS alerts, send the command:
alert off
4.2 GPRS Internet connection
In order to use web mode, the GPRS internet connection must be configured. To do this, you
need the user name, password and APN for your SIM. This information can be obtained from
your SIM provider.
The GPRS connection can be configured and enabled with a single SMS by combining the
commands. For example, to configure and enable a connection with the username and password
internet, and APN gprs.example.com, send the following message:
gprs user internet pass internet apn gprs.example.com on
After sending the settings, you will receive one or more replies indicating the status of the
connection.
Note: Although the SMS commands are not case sensitive, the values for the username and
password may be. Ensure that you use the same capitalization as specified by your SIM provider.
7