Dolphin 12V-30A Manual De Instrucciones página 2

SM Battery Chargers - English Version
Warnings
Before Operation
The manual contains vital and essential information. The owner should read and understand this important document
before operating the charger. Contact REYA if you do not understand a statement.
Before Installation
In order to avoid overcharging or irreversible damage to the materials, please follow closely all recommendations
cited below. Do not install this system near inflammable materials. An owner should seek guidance from an
authorized DOLPHIN dealer or the factory.
•
Do not install this system near a heat source
•
It should not be installed in an airtight or badly ventilated area.
•
All ventilation ducts must be unobstructed
•
Mount in a vertical position, to create natural ventilation for the charger. Note that the wiring connections are at
the bottom of the charger. Leave at least three inches clearance above and below the unit for proper ventilation.
•
This system should not be exposed to water or dust.
•
It is strictly forbidden to tamper with the system casing.
Hazardous Conditions
Can result from improper installation and:
•
Can cause serious injury or death of the occupants.
•
Can cause serious damage or destruction of the vessel.
Serial Numbers
The serial numbers are on the data plate which is located on the right side of the charger. These serial numbers
indicate the year, month, and sequence in which the charger was manufactured. The first letter in the serial number
represents the month it was manufactured (i.e. A-January, B-February, etc.). The following two numbers represent
the year the charger was manufactured and the remainder of the serial number simply indicates the sequence in
which that particular charger was manufactured.
Basic Installation Guide
A. Connection precautions
•
This system is set to be connected to a monophase network 230v 50Hz or 115v 60Hz
•
There is an automatic 115v/230v selection.
•
For security reasons, the system's PE terminal must strictly be connected to the installation's Earth
(green/yellow wire in the cable section)
•
To prevent overheating, ensure the correct connection of cables.
NB: If an inverse polarization of the batteries occurs, the battery fuses will automatically blow.
B. Start up precautions
• In order to prevent all risk of electric shocks at either start up or during the utilization of this system, the
protection cap must rest in place and be tightly screwed.
C. Maintenance precautions
In order to prevent risk of electric shocks during maintenance, please follow closely all recommendations below
before any maintenance begins.
• Disconnect the cable
• The access to -DC or -BAT must be disconnected in order to avoid transfer of energy.
• Please wait five minutes before accessing the casing as the high tension condensation will need time to
discharge.
• Fuses must be replaced by fuses that have the same characteristics and performance levels.
Page 2