iKEY-AUDIO HDR7 Manual De Instrucciones página 22

2) From there slightly lower the level with the
Rec Level Jog wheel until it does not over-
load (*Note: turning the jog wheel clockwise
raises the signal & counterclockwise lowers
the signal level).
The Input Gain switch (4) is also
used to get a maximum signal level.
The switch changes the overall level
of an incoming signal between 3
padded levels: –20 dB [-], 0 dB [o]
and +10 dB [+]. If a signal is too low,
try to raise it by switching from [-] to [o] or [o]
to [+]. If a signal is too high, try to lower it by
switching from [+] to [o] or [o] to [-].
LINE IN
Optimal Clean Recording
Input Level
Signal Meters
Clipping/Distortion
TIME TUNER
Solution- Slightly scale back Rec. Level jog
fig. 1.8
wheel so the meter does not appear red.
Clipping at Mid-Level
STOP/BACK
G3
Solution- Raise the Rec. Level jog wheel all the
way and lower the input gain until the signal
Conexiones y Control de sistema • Connexions & Utilisation • Anschlüsse und Systemeinstellungen
PHONES/
LINE OUT
barely peaks and can be scaled back so it does
Output
not appear red.
FILE BIT RATE FORMAT
Solution- Turn the Rec. Level jog wheel all the
way up and raise the input gain until the signal
FORMAT STEREO
/MONO
barely peaks and can be scaled back.
*Note: If your recording is not being stored cor-
rectly, you may have to raise or lower the signal
coming from your source directly if possible.
PLAY/PAUSE RECORD
Once your bit rate format, levels and stereo/
mono settings have been made, you are ready
to record. In record mode, simply press the
Connections and System Control
Low-Level Recording
20