Publicidad
Idiomas disponibles
Idiomas disponibles
Piggy-back spade terminal (included)
Speaker wire from the stereo
Mounting the Tweeter Speakers
Before mounting the tweeters, you must choose a location
following the guidelines above.
Before cutting the mounting surface you should verify that there
is enough clearance for the tweeter behind the surface. Refer to
the specifications for clearance information.
1
Route the speaker wires from the included piggyback spade
terminal connector on the speaker to the tweeter location,
away from sources of electrical interference
Connections, page
2).
2
Mark the center location of the tweeter on the mounting
surface.
3
Using a 51 mm (2 in.) hole saw, cut the hole for the tweeter.
4
Place the tweeter in the hole to test the fit.
5
If necessary, use a file and sandpaper to refine the size of
the hole.
6
After the tweeter fits correctly in the hole, mark the mounting
holes for the tweeter on the surface.
7
Remove the tweeter from the hole.
8
Using an appropriately sized drill bit for the mounting surface
and screw type, drill the pilot holes.
Do not drill the pilot holes through the holes on the tweeter.
Drilling through the tweeter may damage it.
9
Connect the speaker wires
10
Place the tweeter in the cutout.
11
Test the tweeter to make sure it plays music correctly.
12
Secure the tweeter to the mounting surface using the
included screws
.
NOTE: Do not over tighten the screws, especially if the
mounting surface is not flat.
13
Push the bezel
onto the tweeter front until it snaps in
place.
NOTE: The bezel attaches securely to the tweeter when you
snap it in place. You should test the tweeter for correct
operation before attaching the bezel.
Configuring the Tweeter Speakers
For proper performance, you must configure the DSP profile on
your stereo for the tweeters.
1
After you connect the tweeters to the FUSION Signature
Series speakers, turn on your DSP-capable stereo.
2
Using the FUSION-Link
settings for the stereo.
3
Select the DSP profile for the FUSION Signature Series
speakers and tweeter, and apply it to the stereo.
Installation Instructions
(Speaker
NOTICE
while observing polarity.
remote control app, open the DSP
™
4
If necessary, fine tune the tweeter output by adjusting the
treble from the tone settings on the stereo.
See the owner's manual for your stereo for more details on
adjusting the tone settings.
Speaker Information
Registering Your SG-TW10 Component Tweeter
Help us better support you by completing our online registration
today.
• Go to www.fusionentertainment.com.
• Keep the original sales receipt, or a photocopy, in a safe
place.
Dimension Drawings
Side View
1
28 mm (1
/
in.)
8
7
47 mm (1
/
in.)
8
Front View
15
74 mm (2
/
in.)
16
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65
for protection in the harsh marine environment from the front of
the speaker. They are not designed to withstand high pressure
water spray, which may occur when you wash down your
vessel. Failure to carefully spray-clean the vessel may damage
the product and void the warranty.
3
Publicidad
