There Is No Sound Coming From The Speakers; The Audio Is Distorted - Fusion Tweeter SG-TW10 Instrucciones De Instalación

Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker grille
with a damp cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.

There is no sound coming from the speakers

• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.

The audio is distorted

• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
Specifications
Max. power (Watts)
RMS power (Watts)
Efficiency (1 W/1 m)
Frequency response
Impedance
Impedance when connected to a
FUSION Signature Series speaker
Recommended amplifier power
(RMS)
Diaphragm material
Min. mounting depth (clearance)
Mounting diameter (clearance)
Compass-safe distance
Operating temperature range
Storage temperature range
Water and dust rating
4
NOTICE
330 W
60 W
91 dB
3 kHz to 20 kHz
4 Ohm nominal
2 Ohm nominal
From 25 to 140 W per channel
Aluminum (hard dome)
1
31 mm (1 / in.)
4
51 mm (2 in.)
1
110 cm (3 ft. 7 / in.)
4
From 0 to 50°C (from 32 to
122°F)
From -20 to 70°C (from -4 to
158°F)
IEC 60529 IP65 (protected
against dust and water ingress)
Installation Instructions