Troubleshooting - Truper ROU-NX3 Manual De Instrucciones

Problem
The router is not
functioning.
The work piece
surface is not smooth
after the cut.
The cutting bit cannot
be installed.
If the problems cannot be solved despite the corrective actions recommended,
12
ENGLISH
Cause
• The cord is disconnected from the power
source.
• The switch is into the "OFF" position.
• The carbon brushes are totally worn.
• The bit is dull.
• The bit speed is cutting in an inappropriate
speed.
• The speed pushing the bit is inappropriate.
• The bit has not the right size for the chuck.
contact a

Troubleshooting

Solution
• Connect the cord to the power source.
• Set the switch into the "ON" position.
• Remove the carbon brushes cap and replace
the old carbons with new ones.
• Set a honed and sharp cutting bit.
• Select the adequate speed for the cutting bit
used.
• Make test cuts in scrap wood to determine the
adequate pushing speed (see page 10).
• Use bits with 1/4" shank with the 1/4" chuck.
Use bits with 1/2" shank with the 1/2" chuck.
Authorized Service Center