Assembly - Truper ROU-NX3 Manual De Instrucciones

Assembly

Cylinder Assembly and Disassembly
• The router motor is housed in the vertical cylinder (A)
going up and down inside the fixed base (B) to adjust the
bit to the height that is the right one to the job to do.
CAUTION
• Before fixing the bit or removing the
chuck, the cylinder shall be removed from the fixed base.
CAUTION • Before disassembling and assembling
the cylinder switch off and disconnect the router from the
power source.
• To remove the cylinder release the lever (C) from the
fixed base bracket.
• Keep the height-adjusting button pressed (D).
• Lift the motor head (E) until removing the cylinder from
the fixed base.
• To assemble back the cylinder double-check the cylinder
slot (F) is aligned with the guide in the base.
• Press the height-adjusting button (D) while setting the
cylinder in the fixed base. Release the button so that the
lock (G) fits in one of the stops (H), depending of the
height of the selected bit to make the job.
• Push the lever (C) to close the bracket.
Bit Set Up
CAUTION
• Before setting or removing
a bit switch off and disconnect the router from
the power source.
• Remove the cylinder (A) from the fixed base as
indicated in the previous paragraph and set the motor
head on a flat surface having the cylinder pointing
upwards.
• Press the axis lock ( I ) to prevent it from rotating.
• With the lock depressed and without releasing use the
wrench included to loosen the chuck nut (J).
• Set the bit (K) into the chuck, the shank must be inside at
least 5/8" to assure the bit will not accidentally fall.
• Firmly tighten the chuck nut using the included wrench to
fasten the bit.
• Release the axis lock ( I ) and double-check the bit is
properly fixed.
• When using the additional base (page 8)
CAUTION
do not use bits with diameters higher than 1
Otherwise the base will get ruined.
• To remove the bit press the axis lock and loosen the
chuck using the included wrench.
Chuck Replacement
• Remove the bit as explained in the previous paragraph.
• Press the axis lock ( I ) to prevent it from rotating.
• Without releasing the axis lock remove the chuck (J)
from the threaded axis (L). Use the wrench turning the
nut counterclockwise.
• Set the chuck with the required diameter into the
threaded axis. Turn the nut clockwise.
E
H
F
D
K
1
/ ".
4
J
I
A
C
B
G
L
A
ENGLISH
H
G
7