WEG CFW701 Referencia Rápida página 26

Fault/Alarm
F0185: It indicates a fault at the pre-charge
Pre-Charge contactor.
Contactor Fault
A0210: Indicates that the drive is in Bypass
Drive in Bypass mode.
mode
A0211: Indicates that the drive is in Fire
Drive in Fire Mode Mode.
„
F0228: Refer to the RS-232 / RS-485 Serial Communication Manual.
Serial
Communication
Timeout
„
A0702: Refer to the SoftPLC Manual.
Disabled Inverter
A0704:
Two Enabled
Movements
A0706:
Reference not
Programmed for
SoftPLC
F0711: Fault in the execution of the SoftPLC.
Fault in the
Execution of the
SoftPLC
A0750: It indicates to the user there is not
Programming AIx for analog input programmed for Main
Main PID Controller PID controller feedback.
Feedback
A0752: It indicates to the user there is not
Programming DIx for digital input programmed for Main
Main PID Controller PID controller
Automatic/Manual Automatic/Manual selection.
Selection
A0754: It indicates to the user that the origin
Programming Local of the speed reference in the Local
Reference (P0221) situation is not programmed for
for SoftPLC SoftPLC.
A0756: It indicates to the user that the origin
Programming of the speed reference in the Remote
Remote Reference situation is not programmed for
(P0222) for SoftPLC SoftPLC.
A0758: It indicates to the user that the
Programming engineering unit parameters for
Indirect Engineering motor speed is not programmed for
Unit 4 (P0516) for Hz Hz or rpm.
or rpm
A0760: It indicates to the user that the Main
Low Level for Main PID controller feedback is low.
PID Controller
Feedback
F0761: It indicates to the user that the Main
Low Level for Main PID controller feedback is low.
PID Controller
Feedback
Quick Parameter Reference, Faults and Alarms
Description
„
„
„
„
The digital input programmed for activating the Bypass
mode is active.
The digital input programmed for activating the Fire
Mode is active.
„
„
Parameter P0231 or P0236 or P0241 is not
programmed in 5, 6 or 7.
Parameter P0263 or P0264 or P0265 or P0266
or P0267 or P0268 or P0269 or P0270 is not
programmed in 20.
Main PID controller is enabled (P1017 in 1 or 2) and
CFW701 frequency inverter run the motor in Local
situation and parameter P0221 is not programmed in 7.
Main PID controller is enabled (P1017 in 1 or 2) and
CFW701 frequency inverter run the motor in Remote
situation and parameter P0222 is not programmed in 7.
Parameter P0516 is not programmed in 13 (Hz) or 3 (rpm).
Parameter P1030 is programmed in 1 and the Main
PID controller feedback value is remaining below the
value programmed in P1031 for the time programmed
in P1032.
Parameter P1030 is programmed in 2 and the Main
PID controller feedback value is remaining below the
value programmed in P1031 for the time programmed
in P1032.
Possible Causes
Defective pre-charge contactor.
Open command fuse.
Phase loss at the L1/R or L2/S input.
P0355 = 1 (incorrect setting for mechanical models
"E" powered by the DC Link. For these models should
be set P0355 = 0).
Incompatible applicative.
Fault during upload of the applicative.
CFW701| 25