Denon AVR-3802 Instrucciones De Operación página 10

ENGLISH
NOTES:
• The on-screen display signals are not output from the color difference (component) video signal
(MONITOR OUT) jacks.
• The on-screen display signals are output with priority to the S-VIDEO MONITOR OUT jack during playback
of a video component. For example, if the TV monitor is connected to both the AVR-3802's S-Video and
video monitor output jacks and signals are input to the AVR-3802 from a video source (VDP, etc.) connected
to both the S-Video and video input jacks, the on-screen display signals are output with priority to the S-
Video monitor output. If you wish to output the signals to the video monitor output jack, do not connect a
cord to the S-VIDEO MONITOR OUT jack. (For details, see page 16.)
• The AVR-3802's on-screen display function is designed for use with high resolution monitor TVs, so it may
be difficult to read small characters on TVs with small screens or low resolutions.
• The setup menu is not displayed when "HEADPHONE ONLY" is selected.
• Speaker system layout
Basic system layout
• The following is an example of the basic layout for a system consisting of eight speaker systems and a
television monitor:
Subwoofer
Front speaker systems
Set these at the sides of the TV or
screen with their front surfaces as flush
with the front of the screen as possible.
With the AVR-3802 it is also possible to use the surround speaker selector function to choose the best layout for
a variety of sources and surround modes.
• Surround speaker selector function
This function makes it possible to achieve the optimum sound fields for different sources by switching
between two systems of surround speakers (A and B).
A A
B B
SB SB
Using A only
10
Center speaker system
Surround back speaker systems
Surround speaker systems
A A
B B SB: SURROUND BACK SPEAKER
SB SB
Using B only
Before setting up the system
1
Check that all the connections are correct, then turn on the main unit's power.
2
Display the System Setup Menu.
SETUP
Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to Multi.
1
At the System Setup Menu, select "Power Amp
TUNING
ENTER Assignment" and press the ENTER button.
BAND MODE
SHIFT
TUNING
2
Select "Surround Back" to use
TUNING as the surround back channel,
"Multi" to use as multi zone
BAND MODE
out.
TUNING
3
Enter the setting.
ENTER
The System Setup Menu reappears.
SHIFT
Setting the type of speakers
• The composition of the signals output from the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used.
1
At the System Setup Menu select "Speaker Configuration".
TUNING
BAND MODE
TUNING
When "Surround Back" is selected When "Multi" is selected