Whale Watermaster Manual De Instrucciones página 4

Swim 'n'
Elite
Rinse exterior
Faucet
shower
Aquasource
Clear
Quick Connect
elbow
Watermaster Socket
Quick Connect Tee piece
Whale underfloor
gas and electric
space heater
Exterior
Water
Source
10.i Mounting Instructions
Step 1 Locate in a dry position with adequate ventilation and no more than 3m (9ft) above the water tank. In normal use,
ensure the pump cannot be submerged in water.
Step 2 Ensure pump is mounted free of obstacles and accessible for maintenance.
Step 3 In a marine application, the pump can be mounted horizontally or vertically. In a RV/caravan application the pump
must be mounted vertically. We recommend that the pump head is mounted below motor level (Figure 2). For
advice on your specific installation, please contact Whale® support.
Step 4 Feet positions are adjustable to allow for retrofit. Use 3 stainless steel
screws and washers (supplied with retail pump) to fasten pump to
solid surface and support the pump securely. See Figure 3.
Marine
Models
Fig 2 - Recommended Pump Mounting Orientation
10.ii Plumbing
• Check pump flow direction (as indicated on pump body) and ensure that a
strainer (supplied with retail pump) is attached to the pump head inlet (Figure
4).
• Never use pipe sealant or sealing tapes on threaded adaptors, as these may
enter the pump and cause failure.
Fig 4 - Attach Strainer
to Pump Inlet
• For FW or FP models, ensure a double click into Quick Connect connections (Figure 5).
• For FT models a 1/2" male NPT threaded connection is provided for use with a female NPT allowing easy
connection onto your existing pipework.
• For retail units, 1/2" threaded and barbed connectors are also provided for alternative installation. These
can be easily connected into the Quick Connect head
Elegance
Combination
Mixer
Quick
Whale®
Connect
Watermaster
Straight
Surge
Damper
RV / Caravan
Models
Fig. 1b Typical Installation in a RV System
(Illustration for guidance purposes only)
Whale Rapid
Heat Water
Heater
Drain
Point
Fig 5 - Attaching Pipework
Fig 3 - Secure the Pump
FW / FP Models -
Double Click to Secure
4