Before Installation; Choosing An Installation Site - mundoclima MVD DC2 Manual De Instalación Y Usuario

Ocultar thumbs Ver también para MVD DC2:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Accessories
Verify that the air conditioner includes the following accessories.
Code
1
2
3
4
5
6
7
8
Accessories to purchase locally
Code
Name
Appearance
1
Copper pipe
PVC pipe
2
for water
discharge
Insulation
casing for
3
piping

1. Before Installation

1. Determine the route to move the unit to the installation site.

2. Choosing an Installation Site

1. Choose a site that fully complies with the following conditions and user
requirements to install the air conditioning unit.
Well ventilated.
Unobstructed airflow.
Strong enough to bear the weight of the indoor unit.
Ceiling has no obvious slant.
There is sufficient space for repair and maintenance work to be carried
out.
No leakage of flammable gas.
The length of the piping between the indoor and outdoor units is within
the permitted range (refer to the manual on installation of the outdoor
unit).
There is enough space for installation and maintenance.
The ceiling is at a level position, and the structure is strong enough to
support the device.
Air flows in/out of machine is not obstructed, and the external air
exerts minimum impact.
The supplied airflow can be sent to every corner in the room.
Where it is easier to drain fluids from the connected piping and water
discharge piping.
No direct heat radiation.
Name
Installation Manual
Hook anchor
Boom
Water discharge hose
Hose clamp
Assembling bolt unit
(M8x30CS)
Brass nut
Weak electric cable group
Dimensions
Choose and purchase copper pipes
that correspond to the length and size
calculated for the selected model in the
installation manual of the outdoor unit
and your actual project requirements.
Outer diameter: 37-39 mm, inner
diameter: 32 mm
The inner diameter is based on the
diameter of the copper and PVC pipes.
The thickness of the pipe casing is 10
mm or more. Increase the thickness of
the casing (20 mm or thicker) when the
temperature exceeds 30°C or the
humidity exceeds RH80%.
Appearance
Qty
To purchase based on
actual project requirements.
To purchase based on
actual project requirements.
To purchase based on
actual project
requirements.
Caution
!
Installing the unit in the following places may cause it to
malfunction (please enquire if it is unavoidable):
Presence of mineral oil such as machine oil for cutting.
High salt content in the air such as the sea.
Areas like hot springs where there are corrosive gases like
sulphur gases.
Factories with major voltage fluctuations in the power supplies.
Places like a car or cabin room.
Areas filled with cooking oil and gas like the kitchen.
Presence of strong electromagnetic waves.
Presence of flammable gases or materials.
Areas where there is evaporation of acid or alkaline gases.
Other special environmental conditions.
21
Qty
1
2
2
1
1
4
1
1
Note
Note
Use to connect indoor
refrigerant piping.
Use to discharge
condensed water from
the indoor unit.
Protect piping from
condensation.

Publicidad

Tabla de contenido
loading

Tabla de contenido