Palazzetti ECOPALEX Glass Manual De Instalación, Uso Y Mantenimiento página 33

5.8 FITTING THE TELESCOPIC PIPE
This is the case when you are installing the appliance in
on the right and then pulling it out from the left bush.
pipe downwards and put it in place. Lastly, remove any
excess ealant from inside and put the exaust valve back
in place as well as the cast iron smoke diaphragm. The
5.9 OPTIONAL FAN CONTROL UNIT KIT
In the version with axial fans, they can be turned on
SWITCHES FOR THE FANS
The electrical circuit features a minimum temperature
occurs after 15-20 minutes depending on the size of the
can also work without the fans on.
The control unit and all electrical parts must be installed
and connected by skilled personnel in compliance with
current standards. It must be possible to inspect and
remove the control unit and all the electrical parts for
maintenance or repairs.
5.9.1 The "680" fan kit including the control unit
(optional)
When you wish to distribute heated air through more
complex ducts, use the "680" fan, setting up the entire
system as indicated previously and in the instructions
of the kits.
5.9.2 Axial fans kit (optional)
When no air ducting is necessary but you wish to facilitate
heat distribution, the product can be equipped with two
axial fans to force air from the front grilles.
To do so, remove the front grille and secure the two axial
cable exits from the left side of the product and that the
thermostat is always fastened behind the left fan.
For assembly, see the instructions in the kit.
33
- 5.16 -
- 5.17 -
- 5.18 -