Husqvarna SMR 511 2012 Manual De Uso página 72

ENGINE OIL REPLACEMENT AND MESH FILTERS-FILTER
CARTRIDGE CLEANING OR REPLACEMENT
WARNING*: Be careful not to touch hot
engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
Remove oil filler cap (2);
-
put a drip pan under engine;
-
remove oil drainage plug (3);
-
evacuate the exhausted oil, and clean magnet on plug (3);
-
1
2
4
3
SPECIFICATIONS - OPERATION - MAINTENANCE
EN - 22
- loosen the two caps (4), and remove the two mesh
filters (5) and (6);
- check for O-rings (7) conditions. If worn, change them.
Then clean filters (5) and (6) using gasoline;
- reassembly is a reverse of removal.
- undo cap (8) and remove cartridge filter (9);
- replace filter (9), lubricate O-ring (10), and screw cap
(8);
- once filter has been replaced, refit oil drainage plug
(3), and pour the recommended quantity of oil.
5
7 7
6
7
7
WARNING
Start the engine to allow the oil to reach
all the points of the engine and check
the level as described in the relevant
paragraph.
To check that the oil quantity does
not exceed the "MAX" level notch,
set the motorcycle on the side stand
and check that in this position the le-
vel goes below the "MAX" notch by
looking through the inspection sight
glass (1).
7 4
7 4
8
9 10 8