Reel Motor Mounting - Textron JACOBSEN G-Plex III DN Serie Manual De Seguridad Y Operacion

8 SETUP
GB
8.3

REEL MOTOR MOUNTING

1. The cutting head motor mounting adaptor,
coupling and hardware are shipped in the
step located above the left front wheel.
Install a 1.49" i.d. x .07" (38mm x 1.7mm)
O-ring on the male side of motor adapter
plate and a 1.99" i.d. x .07" (50mm x
1.7mm) O-ring on the reel motor mount
face.
2. Remove and discard screws holding the
shipping cover to cutting head (retain the
shipping cover to protect the bearings
whenever the motor is removed from the
cutting head).
3. Install coupler on cutting head shaft (See
Fig. 8.3.1).
4. Install motor adapter plate positioning the
male face and O-ring toward the cutting
head (See Fig.8.3.1).
5. Install two (2) 5/16-18 x 1 1/2" screws
(with washer and lock washer) loosely into
the mounting holes (See Fig 8.3.2).
6. Align the splines on the motor shaft with
the coupler and slide the motor into place
rotating approximately 45_ away from the
mounting screws. With motor face against
adapter plate, rotate the motor mounting
flange into place engaging the screws into
the motor mounting flange slots. Tighten
screws to 18ft/lbs (24 N·m).
7. Add lithium based lubricant to the bearing
housings at BOTH ends of the reels
(reference lubrication fitting in Figure
8.3.2). Bearings at both ends are partially
packed with lubricant at the factory, but
additional lubricant is required once
assembled. Use a pressure gun to add
lubricant until it starts to escape from the
fittings. Wipe off any excess lubricant.
NOTE: Check to MAKE SURE when the cutting
heads are lowered to the turf, they must
contact the turf evenly across the entire
length of the cutting head. If the front
cutting heads contact the level surface
unevenly, refer to the adjustment section
in the parts and maintenance manual.
GB-20
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
O-RING
Fig.8.3.1
Motor Mounting
1
Fig.8.3.2
Motor Mounting Screws & Lubricator
COUPLER
ADAPTER
2
1