MSA SingleLine SCOUT Manual De Instrucciones página 7

Assembling SingleLine SCOUT
For assembling the device, a Torx spanner and a small screw driver are required.
(1) Unscrew the battery cover of the device with a Torx T10
spanner.
(2) Remove the battery cover.
(3) Remove the U-clip with a small screw driver.
(4) Push the SingleLine into the attachment point.
(5) Secure the SingleLine with the U-clip.
(6) Insert the batteries. Follow insert direction printed in
battery compartment. Only use certified batteries (see
chapter 7).
(7) Close the battery compartment with a Torx T10 spanner
(0.7 Nm).
(8) Perform a tightness check (see chapter 4.1).
SingleLine SCOUT
Installation
GB
7