NOCCHI SENSORMAT Manual De Uso página 31

involved. With keys (16)
to the first pump (in the case of this example it is for 5.0 Bars - normally from 0.5 to 1.0 lower than maximum
pressure). Press key (18)
the the case of this example its for 5.0 BARs - normally from 0.5 to 1.0 lower than the maximum pressure). The following
message will be displayed:
PRES. Bar PO:2
MAX05.2 MIN04.7
- Line n. 1 PRESS. BAR PO: 2
Indicates the number of pumps to which the pressure levels of the following line refer to
- Line n. 2 MAX0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the second pump. Press key (18)
confirming with key (18)
value assigned to pump 1).
- Line n. 2 MIN0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the second pump (in the case of this example it is for 4.7 Bars - normally from 0.5 to 1.0 lower than maximum
pressure). Press key (18)
the case of this example it is for 4.7 BARs - normally from 0.5 to 1.0 lower than the maximum pressure). The following
message will be displayed:
PRES. Bar PO:3
MAX04.9 MIN04.4
- Line n. 1 PRESS. BAR PO: 3
Indicates the number of pumps to which the pressure levels of the following line refer to
- Line n. 2 MAX0X.XS
+
With keys (16)
(normally 0). Confirm by pressing key (18)
units involved. With keys (16)
assigned to the pump which will be started third.
ENTER
Press key (18)
case of this example its for 4.9 BARs (normally 0.3 to 1.0 lower than the value assigned to pump 2).
+ -
-
+
or (17)
and set the pressure decimal value always confirming with key (18)
ENTER
-
or (17) set the number in tens of minimum pressure values for the second pump
ENTER
+
or (17)
ENTER
. In the case of this example it is for 5.2 bars (normally 0.3-1.0 bars lower than the
-
or (17) set the number in tens of minimum pressure values for the second pump
ENTER
+
or (17)
ENTER and set the pressure decimal value always confirming with key (18)
-
or (17) set the number in tens of maximum pressure value of the third pump
ENTER
+
or (17)
and set the pressure decimal value always confirming with key (18)
set the number of minimum pressure units (in BARs) assigned
. The cursor will change position depending on the number of
-
set the number of minimumpressure units (in BARs)
ENTER
and set the pressure decimal value always
. The cursor will change position depending on the number of
-
set the number of minimum pressure units (in BARs)
. The cursor will change position depending on the number of
-
set the number of minimum pressure units (in BARs)
GB
ENTER
(in
ENTER
(in
ENTER
in the
29