Graco 4EVER Manual De Instrucciones página 98

Locking Clip
located on the back of the backrest.
1" (2.5 cm)
98
Sliding Latch Plate and ELR
Retractor
A latchplate that slides freely on the
belt webbing and cannot, by itself,
hold the belt snug around a car seat.
With this retractor, you will need
to use the locking clip to lock the
vehicle seat belt.
Route the vehicle seat belt through
the proper belt path and buckle it
in. Pull the vehicle seat belt tight.
While pushing down on seat, pinch
the two straps together behind the
buckle tongue. Unbuckle the belt
without allowing it to slip.
Attach locking clip to lap and
shoulder belts as shown.
Rebuckle belt. Check that lap belt
does not move by pulling hard. If
belt loosens or lengthens, repeat
procedure.