Operating Unit; Cleaning & Storage - Steamfast SF-717 Guia Del Usuario

OPERATING UNIT

DRY IRONING
IMPORTANT: Make sure Steam Button is locked in lowered
position (FIGURE 4-B) before dry ironing. This will prevent any
water from accidentally dripping.
1. Plug power cord into a convenient electrical outlet.
2. Turn Temperature Control Dial clockwise so that small arrow (
on Hand Grip (FIGURE 3-A) points to one of three heat settings on
Dial (FIGURE 3-B). Heating Indicator Light will illuminate.
NOTE: It is recommended to start with lower temperatures
first, as high settings designed for heavy materials can
damage delicate fabrics.
3. When Heating Indicator Light turns off, Ironing Plate is heated and
ready for use.
NOTE: During use, Heating Indicator Light will cycle on and
off as unit works to maintain a constant temperature. You
may continue to iron while Light cycles.
STEAM IRONING
1. Plug power cord into a convenient electrical outlet.
2. Turn Temperature Control Dial clockwise as far as possible to
set unit to high temperature (MAX •••). Heating Indicator Light will
illuminate.
3. When Heating Indicator Light turns off, press Steam Button.
Button will lock into raised position (FIGURE 4-A), and unit will
begin emitting steam from steam vents on Ironing Plate.
NOTE: Unit is designed to steam horizontally. Steam flow will
stop whenever unit is in vertical upright position.
4. To stop steam flow, press Steam Button again to lock it into
lowered position (FIGURE 4-B).
Once all ironing tasks are finished, immediately turn Temperature Control Dial counter-clockwise
until it is set to off (O) position. Be sure that Steam Button is locked in lowered position - this
will prevent water from accidentally dripping during next use. Prop unit upright on Stands to cool,
and refer to CARE & STORAGE GUIDELINES on Page 9 for proper cleaning and storage.
8 | ENGLISH
A
ARROW
)
B
Synthetics, Silks
(LOW TEMP)
Wool
(MEDIUM TEMP)
Cotton, Linen
(HIGH TEMP)
FIGURE 3
A
B
FIGURE 4
Product Information
CLEANING & STORAGE
1. Turn Temperature Control Dial to "off" (O) position. Unplug power cord.
2. Prop unit upright on Stands and allow Ironing Plate to cool for 30 minutes.
3. Open Water Tank Cap and drain any remaining water into a sink or tub. Close
Cap when finished.
4. Wipe Main Body and Ironing Plate with a soft cloth lightly moistened with water.
• DO NOT clean Ironing Plate with detergents or descalers
• DO NOT clean Ironing Plate with abrasive or corrosive products
• DO NOT submerge unit or hold unit under running water.
5. Wrap power cord around base of Hand Grip
and secure end in Power Cord Clip as shown
(FIGURE 5). Place unit and Measuring Cup inside
Travel bag and store in a cool, dry location.
MINERAL BUILD-UP
1. Follow STEPS 1-3 under CLEANING & STORAGE section above; however,
leave Water Tank Cap open.
2. Make a mixture of 0.5 oz. distilled water and 0.5 oz. vinegar.
3. Using included Measuring Cup, pour water-vinegar solution into Water Tank.
Close Water Tank Cap.
4. Follow normal steam ironing procedure, as outlined on Page 8. Allow unit to
steam out full contents of Water Tank. When finished, lock Steam Button in
lowered position and unplug unit.
5. Allow to cool for 5 minutes, then refill Water Tank with fresh distilled water.
Repeat STEP 4 until vinegar odor dissipates.
6. Store unit as normal.
FIGURE 5
ENGLISH | 9