Jacuzzi BUILDER Serie Manual De Instalación Y Operación página 3

PRECAUTIONS
Do not operate the whirlpool system unless the bath is filled with water to at least 1" above the highest jet.
Do not immerse the control panel by overfilling the bath.
Do not use oil-based bath additives in your whirlpool bath.
When cleaning your bath, do not use abrasive substances which will damage the bath's surface.
To prevent discoloration of the acrylic finish, do not fill the bath with water in excess of 140°F (60°C).
The whirlpool system should be purged at least twice a month. For your convenience, we have devel-
oped a plumbing system cleaner (Systems Clean™) specifically for whirlpool baths. For availability call
1-800-288-4002.
Use this unit only for its intended purpose as described in this manual. Do not use attachments not
recommended by the manufacturer.
A pressure wire connector is provided on the exterior of the motor to permit connection of an No. 8 AWG
(8.4 mm) solid copper bonding conductor between this unit and all other electric equipment and exposed
metal in the vicinity, as needed to comply with local requirements.
This unit should be electrically grounded and installed by a licensed contractor, electrician, and plumber.
For built-in and drop-in units, install to permit access for servicing.
Note: This is a professional grade product. A knowledge of construction techniques, plumbing and electri-
cal installation according to codes are required for proper installation and user satisfaction. We recom-
mend that a licensed contractor perform the installation of all Jacuzzi Whirlpool Bath products. Our war-
ranty does not cover improper installation related problems.