remove the Battery Pack from the drill housing
and cover the Battery Pack connections with
heavy-duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt
to open or remove any of the components.
TROUBLESHOOTING
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The Forward/Reverse Rotation Control (4),
which is on top of the trigger, is positioned in
the lock function. Unlock the Forward/Reverse
Rotation Control by putting it into the required
rotation position. Push the trigger and the drill
will start to rotate.
2. THE DRILL STOPS BEFORE THE
SCREW IS COMPLETELY TIGHTENED.
WHY?
Verify the torque position of the Torque
Adjusting Ring. You can find the Torque
Adjusting Ring between the Chuck and the
drill body. Position 1 is the lowest torque
(screw driving force) and position 15 is the
highest torque (screw driving force). Position
16 is for drill operation. Regulate the Torque
Adjusting Ring to a higher position to reach
the best result.
3. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a Battery Pack (8) for a
prolonged time will reduce the Battery Pack
working time. This can be corrected after
several charge and discharge operations by
charging & working with your drill. Heavy
working conditions such as large screws into
hard wood will use up the Battery Pack energy
faster than lighter working conditions. Do
not re-charge your Battery Pack below 32°F
(0
C) and above 113°F (45
o
performance.
MAINTENANCE
Your tool requires no additional lubrication or
maintenance.
20V Cordless Drill / Driver
C) as this will affect
o
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
11
EN