Declaration Of Conformity Ce - SILESTONE Integrity Guia De Instalacion

5. Applying Silicone Onto The Sink.
Apply the silicone onto the sink edge. You must use the
correct colour COLORSIL silicone to bond the sink and
countertop (COLORSIL is provided together with the sink).
6. Fitting The Sink To The Underside
Of The Countertop.
Once the silicone has been applied. The sink should be
offered up to the countertop by using the anchorage
system and adjusting the support bolts. Level the sink to
ensure a good silicone bond between the countertop and
the sink is achieved.
Care must be taken to ensure a perfect bond and not to
over-tighten the bolts.
Clean off any excess silicone before it dries. Cosentino
recommends using CLEANCOLORSIL. Do not use any
products containing METHYLINE CHLORIDE.
Telescopic
Rod
Installation Guidelines Integrity by Silestone®
Countertop
Sink
Declaration of
Conformity CE
Declaration of conformity to the European
Union directives.
Cosentino S.A,in A-334 road, km 59 (04850)
Cantoria Almería, declare under exclusive
responsibility the conformity of the product:
Type : Silestone Sink
Name: ONE and DUE
Use: Domestic use.
To which this declaration is referred, with
the norms or another normative documents:
UNE-EN 13310: Kitchen sinks. Functional
requirements and test methods.
And that it is conform with COUNCIL
DIRECTIVE of 21 December 1988 on the
approximation of the laws of the Member
States relating to materials and articles
intended to come into contact with
foodstuffs (89/109/EEC).
Note
COSENTINO S.A recommends the use of
anchorage kit in all models of Integrity sinks
in order to guarantee a safer and firmer
fastening.
COSENTINO S.A states that the use of
moorings kit with the XL Integrity model is
needed and for this reason it is obligatory
with this model. Damages due to an incorrect
sink installation will be assumed by the fitter
and not by COSENTINO S.A
2
11