Ec Declaration Of Conformity - SILESTONE Integrity Guia De Instalacion

OPTION B. Installation with
telescopic bars.
Accessory on request, please check availability with your
local COSENTINO Center.
The kit consists of the following items:
SUPPORT PROFILES (x2)
SCREWS (x4)
Fitting the support profiles:
These profiles are fixed with screws to the sides of the
kitchen unit (one on each side). The base of the profile
must be 21cm from the underside of the worktop.
Fitting the telescopic bars:
The length of these telescopic bars can be increased or
decreased depending on the size of the unit. They are
between a minimum of 50cm and a maximum of 90cm
or 120 cm (with an extender included) in length. They
are placed transversely, with their ends supported by the
slots in the support profiles.
For under-worktop installation, once the back bar
is in place, support the sink and fit the front bar. Place
the sink in the cut-out hole and apply ColorSil. Tighten
the Allen bolts so that the sink is completely bonded to
the worktop and in line with the perimeter of the hole.
Once it is in place, remove the excess silicone from
the sink before it dries. Cosentino recommends using
CLEANCOLORSIL to remove it. Do not use any products
containing METHYLINE CHLORIDE.
TELESCOPIC HOLDING BARS (x2)
21 cm
Installation manual Integrity by Silestone®
2
Support
profiles
Bolts
In the case of an integrated or mitred installation, use
the fastening belts to reinforce the anchorage. Tighten
the Allen bolts to ensure that the bars are in contact with
the entire length of the sink.
If you have any questions, please contact your local
COSENTINO Center.
EC Declaration of
Conformity
Declaration of Conformity to the European Union
directives.
Cosentino S.A. declares under its sole responsibility the
conformity of the products under the Integrity brand.
Use: Domestic use, to which this declaration refers,
in accordance with the relevant standards or other
standardising documents.
Note
COSENTINO S.A recommends the use of one of the two
anchorage kits in all models of Integrity sinks to ensure
a safer and firmer fastening.
COSENTINO S.A declares that the use of one of the two
anchorage kits is necessary for the Integrity DUE XL sink
and therefore mandatory for this model. Any damage
resulting from the incorrect installation of the sink shall
be borne by the fitter and not by COSENTINO S.A.
If you wish to fit a waste disposal unit, COSENTINO S.A.
recommends that it be equipped with a system that
absorbs the vibrations emitted, such as a soundproofing
plate, and that the necessary plumbing connections,
both to hold the disposal unit and to connect it to the
water outlet, be made of flexible PVC.
If you wish to fit a boiling water tap (e.g. Quooker®),
COSENTINO S.A. recommends that the water never falls
directly into the Integrity sink by Silestone. This type of
tap has been tested with different cycles of hot and cold
water, at temperatures up to 96ºC. Any liquid at a higher
temperature has not been tested and could damage the
sink, rendering it out of the COSENTINO warranty.
Countertop
Sink
Telescopic
bar
19