Publicidad
Idiomas disponibles
Idiomas disponibles
9.
Engage trigger loci< to spray gun trigger (Figure 10).
Trigger Loci<
WARNING
. When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
. If engine starts and fails to continue
to run or if increased
resistance is felt during starting pull attempts,
squeeze trigger
on spray gun.
WARNING
10. When starting engine, position yourself as recommended
in Figure I I and start engine according to instructions
given in engine user's manual.Also see operating
instructions tag located on the pressure washer.
. DO NOT touch
hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
The pressure washer must be at least 5 feet from structures
having combustible
walls and/or other combustible
materials.
Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance
and servicing.
Reflective exhaust heat may damage fuel tank causing fire.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered
by an internal
combustion
engine to have a spark arrester, maintained
in
effective working
order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California
a
spark arrester
is required under section 4442 of the California
Public resources
code. Other
states may have similar laws.
NOTE:
Always keep the throttle
lever in the "Fast"
position
when operating
the pressure
washer.
How
to
StopYour
Pressure
Washer
I.
Let engine
idle for two
minutes.
2.
Turn
engine
off according
to instructions
given in
engine
user's
manual.
3.
Squeeze
trigger
on spray
gun
to
relieve
trapped
pressure
in hose
to avoid
injury.
WARNING
Keep high pressure hose connected
to pump and spray gun
while system is pressurized.
Squeeze trigger on spray gun to relieve trapped pressure,
every time you stop engine. Engage trigger lock on spray gun.
Publicidad
