Descargar Imprimir esta página

Important - Snapper 2650 PSI Instrucciones De Uso

Ocultar thumbs Ver también para 2650 PSI:

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Allowdetergent to soak inbetween 3 -5minutes
before washing andrinsing. ReappJy
asneeded to
prevent surface fromdrying. DoNotallowdetergent
to dryon(prevents streaking).
IMPORTANT:You must f lush thechemical injection
system aftereach usebyplacing thefilterintoabucket of
clean w ater, thenrunthepressure washer inlowpressure
for 1=2 minutes.
Pressure
Washer
Rinsing
For Rinsing:
I.
Apply safety latch to spray gun.
2.
Remove
black chemical
nozzle from nozzle extension.
3.
Select and install desired
high pressure
nozzle following
instructions
"How to Use Spray Tips".
4.
Keep spray gun a safe distance
from the area you plan
to spray.
WARNING
. Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
. Operate this unit on a stable surface.
. Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
. Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
5.
Apply a high pressure
spray to a small area and then
check the surface
for damage. If no damage
is found,
you can assume
it is okay to continue
rinsing.
6.
Start at top of area to be rinsed, working
down with
same overlapping
strokes
as you used for cleaning.
Cleaning
Detergent
Siphoning
Tube
If you used the detergent
siphoning tube, you must flush it
with clean water before stopping the engine.
I.
Place chemical injection siphon/filter
in a bucket full of
clean water.
.
3.
4.
Attach
black low pressure
spray tip.
Flush for 1-2 minutes.
Shut off engine.
iMPORTANT:
Simply shutting OFF engine will not
release pressure in the system. When
the engine
has
shut down, squeeze
the trigger
on the spray gun to
relieve the pressure
in the hose.
Automatic
Cool
Down
System
(Thermal
Relief)
If you run the engine on your pressure washer for
3-5 minutes without
pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°EThe system engages to cool the pump by
discharging
the warm
water
onto
the ground.

Publicidad

loading