Publicidad
Idiomas disponibles
Idiomas disponibles
SNAPPER
"°
WARNING
, DO NOT touch
hot surfaces and avoid hot exhaust gases.
, Allow equipment
to cool before touching.
, The pressure washer must be at least 5 feet from structures
having combustible
walls and/or other combustible
materials.
, Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance
and servicing.
, Reflective exhaust heat may damage fuel tank causing fire.
, Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered
by an internal
combustion
engine to have a spark arrester, maintained
in
effective working
order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California
a
spark arrester
is required under section 4442 of the California
Public resources
code. Other
states may have similar laws.
WARNING
, DO NOT wear loose clothing, jewelry
or anything that may
be caught in the starter or other rotating
parts.
, Tie up long hair and remove jewelry.
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRSTOYOUR
PRESSURE
WASHER
, Disconnect
spark plug wire from spark plug and place wire
where
it cannot
contact
spark plug.
WHEN
TESTING
FOR ENGINE
SPARK
" Use approved
spark
plug tester.
, DO NOT
check for spark with spark
plug removed.
WARNING
i
DO NOT tamper
with governed
speed.
DO NOT
operate
pressure
washer
above rated
pressure.
CAUTION
DO NOT
secure
spray gun in open
position.
DO NOT
leave spray gun unattended
while machine
is
running.
NEVER use a spray gun which
does not have a tri;_er
loci< or
trigger
guard
in place and in working
order.
Always
be certain
spray gun, nozzles
and accessories
are
correctly
attached.
CAUTION
DO NOT point spray gun at glass when in jet spray mode.
NEVER aim spray gun at plants.
CAUTION
If you have questions
about
intended
use, ask dealer
or
contact
Bri;_s & Stratton
Power
Products.
NEVER operate
units with
broken
or missing parts,
or
without
protective
housing
or covers.
DO NOT
by-pass
any safety device
on this machine.
Before
starting
pressure
washer
in cold weather,
check all
parts
of the
equipment
to be sure ice has not formed
there.
NEVER move
machine
by pulling on high pressure
hose. Use
handle provided
on unit.
Check
fuel system
for leaks or signs of deterioration,
such as
chafed or spongy
hose,
loose or missing clamps,
or damaged
tank or cap. Correct
all defects
before
operating
pressure
washer.
This equipment
is designed to be used with Bri_s
& Stratton
Power Products
authorized
parts ONLY.
If equipment
is used
with parts that DO NOT comply with minimum
specifications,
user assumes all risks and liabilities.
, Always wear
eye protection
when
using this equipment
or in
vicinity of where
equipment
is in use.
Publicidad
