Publicidad
Idiomas disponibles
Idiomas disponibles
I.
.
.
4.
Detach spray gun and nozzle extension from high
pressure hose. Detach nozzle extension from spray
gun and remove o-ring and screen from nozzle
extension. Flush screen, spray gun, and nozzle
extension with clean water to clear debris.
Place in-line filter screen into threaded end of nozzle
extension. Direction
does not matter. Push screen in
with eraser end of pencil until Jt rests flat at bottom
of
opening.Take care to not bend screen.
Place o-ring into recess. Push o-ring snugly against
in-line filter screen.
Assemble nozzle extension to spray gun, as described
earlier in this manual.
Nozzle
Maintenance
A pulsing sensation felt while squeezing the spray gun
trigger may be caused by excessive pump pressure.The
principal cause of excessive pump pressure is a spray tip
clogged or restricted
with foreign materials, such as dirt,
etc.To correct
the problem, immediately
clean the spray tip
following these instructions:
I.
Shut off engine and turn off water
supply.
2.
Remove spray tip from end of nozzle extension.
3.
Remove in-line filter from other end of nozzle
extension.
4.
Use a small paper clip to free any foreign material
clogging or restricting
spray tip (Figure 14).
Use wire
here
to remove
debris.
5.
Using a garden hose, remove additional debris by back
flushing water through nozzle extension
(Figure I 5).
Back flush between 30 to 60 seconds.
6.
Reinstall spray tip and in-line filter into nozzle
extension.
7.
Reconnect nozzle extension to spray gun.
8.
Reconnect water supply, turn on water, and start
engine.
9.
Test pressure washer by operating with each Quick
Connect spray tips.
O-Ring
Maintenance
Purchase an O-Ring/Maintenance
Kit, part number
191922GS by contacting the nearest authorized
service
center. It is not included with the pressure washer.This
kit
includes replacement
o-rings, rubber washer and water
inlet filter. Refer to the instruction
sheet provided in the kit
to service your unit's o-rings.
WARNING
NEVER repair leaking connections
with sealant of any kind.
Replace o-ring or seal.
Publicidad
