Display Message/Alarm Signalling - Kruger KGV9000 Manual De Instrucciones

6. DISPLAY MESSAGE/ALARM SIGNALLING

CAUTION When the dirt in the vacuum cleaner reaches the maximum level allowed, no alarm is
:
displayed on the display, but the float automatically closes the suction opening inhibiting this
function. You will experience a sudden decrease in the suction power and a more acute noise of
the motor.
In this situation, you must switch off the machine, unplug it, disconnect the suction hose, open the
vacuum cleaner and empty / clean it.
STARTING
FILLING
THERMOMETER
HEATING
READY STEAM
CONTROL PANEL
LACK OF LIQUIDS IN THE
TANK ALARM
AUTOMATIC MODE ALARM
REMOTE CONTROL
CONNECTION
kruger.es
Loading at machine's start up
If water in the boiler reaches the set level, the
machine pumps water. At this stage it is not possible
to make any activation
Thermometer on the left side of the display shows
the temperature of the steam in the boiler
This message is displayed each time the heating
element is powered and there is no active function
selection. As long as the machine reaches the
working pressure, you cannot activate any function.
It indicates the ready steam pressure is reached. It is
shown only if no function is active.
It represents the graphics to show the active
functions on both sockets.
One of the three tanks is empty, the arrow relates to
the empty tank and a light switches on intermittently.
This alarm is shown only when selection is set on
"Autom". If after 20 seconds, the machine does not
detect water in the tank, the alarm activates. See
section 5.1.
When the machine detects the wi-fi signal emitted by
a remote control (chapter 8), this symbol is shown in
the right corner of the display.
30