THOMSON MIC250IDABBT Manual De Instrucciones página 26

Preset
1. Preset Recall
In DAB mode, press
station stored in the preset memory.
Note: If you have not previously stored a preset station and the preset button is pressed,
"Empty preset" will be displayed.
2. Preset Store
You may store your preferred DAB stations in the preset station memories. There are 20
memory presets in your radio. Presets are remembered by your radio in the event of a power
failure.
The procedure for setting presets and using them to tune into stations is the same for DAB
modes:
In DAB mode, select the desired wave band. Press [▲, ▼] to view the stored stations, press
to tune to the required station as previously described, and then press ENTER
or
to select the desired preset number under which you will store the station. Press ENTER to
confirm.
FM Radio
Carefully extend the telescopic aerial to its full length.
Auto Scan
1. Rotate the SOURCE knob to select "FM Mode".
2. Long press the
station of sufficient signal strength.
3. After a few seconds, the display will update. The display will show the station frequency. If the
signal is strong enough and the station signal contains RDS data, then the radio will display
the station name.
4. To find other stations, press and hold the
5. To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
6. When the waveband end is reached, your radio will recommence tuning from the opposite
waveband end.
Manual Scan
1. Rotate the SOURCE knob on the main unit to select "FM Mode''.
2. Select FM mode as previously described, if required.
3. Press or
frequency up or down by 100 kHz.
4. When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the
reception by doing another auto scan in a different location.
or to select "Preset Recall", then press [ENTER] to tune to the
button, and your radio will scan and stop automatically when it finds a
to tune to a station. Each press on the tuning button will change the
- EN 9 -
button as before.