Publicidad
Idiomas disponibles
Idiomas disponibles
S RVIC
A
TO REPLACE AUGER SHEAR BOLT
The augers are secured to the auger shaft with special
bolts (See Fig..37) that are designed to break (to protect
the machine) if an object becomes lodged in the auger
housing
Use of a harder bolt will destroy the protection
provided by the shear bolt.
IMPORTANT:
TO INSURE SAFETY AND
PERFORMANCE
LEVELS, ONLY
ORIGINAL EQUIPMENT SHEAR
BOLTS SHOULD BE USED_ WHEN
REPLACING SHEAR BOLTS, BESURE
TO REPLACE SHEAR BOLT
SPACERS.
To replace a broken shear bolt, proceed as follows:
Move the throttle to STOP and turn off all controls
Disconnect the spark plug wire
Be sure all moving
parts have stopped
Remove the broken shear boil
Lubricate
the auger shaft zerk fitting (see the
Customer Responsibilities
section, pages 16-17)
Afign the hole in the auger with the hole in the auger
shaft, install the new shear bolt and shear bolt
spacer provided
Reconnect the spark plug wire
O
O
o
o
TO ADJUST
TRACK
Ifthe snow throwerdoes not move forward evenly and the
track slips slightly, you need to check the track as follows:
®
Pull up gently on the center of the track near the
center.
•
Measure the distance between the track and the top
of the track support frame (See Fig.. 38). The dis-
tance should not be more than one and one quarter
(1-I/4) inches.
If the distance is greater, you need to adjust the track as
follows:
e
Loosen or tighten the adjusting bolt at the rear of the
track support frame (See Fig 38) to obtain the
proper distance between the track and the track
support frame.
•
Adjust the track on the opposite side in the same
manner.
ADJUSTME
TS
LOCKNUT_
FIG. 37
TRACK (properly adjusted)
SUPPORT FRAME
ADJUSTING
BOLT
1-1/4"
TRACK (out of adjustment)
FIG. 38
23
i_
Publicidad
