Removing The Lens - dye INVISION i4 Manual Del Proprietário

• Check for gaps between the foam on the goggle frame and your face. The Goggle System must
create a seal with your face.
• If there are any gaps, the strap is too loose.
• Remove the system from your head and shorten the strap by moving the two slides evenly apart.
The two slides on the goggle strap have teeth to prevent slipping. The teeth preventthe strap
from slipping out of adjustment.
• Put the system back on again and check for gaps.
• If there are no gaps but the system feels too tight, remove the system from your head and move
the two clips evenly together.
UNLOCKED
LOCKING TAB
Figure 1
Figure 2
Figure 3
6
i4-Manual-Multi-Redux-FINAL-cs4.indd 6
WARNING: The i4 Goggle System is NOT designed or intended for
children 12 years of age and younger.

REMOVING THE LENS

Tip: Replace your lens at least once each year. Factory applied
protective coatings on each lens surface will wear off even with gentle
cleaning.
1 Depress the locking tab on the gray retention clip and push the
gray retention clip forward. Perform this on both sides of the
mask.
[See Figure 1]
2 Once both gray retention clips are unlocked and in the forward
position, push on the left and right back corners of the lens,
located behind the gray retention clips.
3
This will separate the lens from the Goggle System frame.
4
Grab the lens from the front by the top center and nose bridge.
Pull the lens out of the goggle.
WARNING: Use only your hands when changing DYE
Use of tools is likely to scratch or damage the lens.
W W W . D Y E P A I N T B A L L . C O M
[See Figure 2]
[See Figure 3]
lenses.
®
9/26/11 10:41 AM