Installing The Lens - dye INVISION i4 Manual Del Proprietário

Figure 4
Figure 5
Figure 6
LOCKED
LOCKING TAB
Figure 7
i4-Manual-Multi-Redux-FINAL-cs4.indd 7

INSTALLING THE LENS

1 The gray retention clips should be in the forward position prior to
installing the lens.
2 Slide the lens through the slots on the side of the Goggle System.
[See Figure 5]
3 Press the lens down against the frame until it is evenly seated
against the frame.
4 Make sure the nose tab is fully seated into the groove of the
frame.
5
The two upper lens tabs should be properly aligned and inserted
into the two top frame slots.
6
Visually inspect the lens to ensure there are no gaps between the
lens and frame.
7
Push the gray retention clip downwards against the mask as you
pull the clip simultaneously rearward. This will ensure the clip
hook engages the lens to lock it into place.
8 As you pull the clip rearward you will hear the locking tab click
into the lock position.
9 Visually inspect the locking tab to see if it has locked into place.
[See Figure7]
10 Visually inspect the back side of the gray retention clip to see
if the clip hook has
engaged the lens. The
gray retention clip will
sit flush against the lens
if it is engaged properly.
[See Figure 8]
engaged and locked in
place you will see the
clip hook exposed.
Figure 9]
W W W . D Y E P A I N T B A L L . C O M
[See Figure 4]
CORRECT
If it is not
[See
[See Figure 6]
WRONG
CLIP HOOK
Figure 8 Figure 9
9/26/11 10:41 AM
E
N
G
L
I
S
H
7