Assembling Your Charger - Blue point EEBC100A Manual De Instrucciones

10. ASSEMBLING YOUR CHARGER

It is important to fully assemble your charger before
use. Follow these instructions for easy assembly.
PARTS:
(6) #10-32, thread-cutting screws
(4) ¼-20, thread-cutting screws
(2) wheels
(1) axle
(2) axle E-clips
(2) axle brackets
(1) handle assembly
(1) foot
(2) flat washers
TOOLS NEEDED:
3/8˝ wrench (for mounting foot)
5/16˝ wrench (for mounting axle)
10.1 ATTACH THE FOOT: Remove the charger from the
packing materials and place upside down on a flat
surface. Attach the foot and secure it with the four ¼-20
thread-cutting screws provided.
10.2 ASSEMBLE THE WHEELS AND AXLE: Install an E-clip
to one end of the axle. Slide one wheel onto the axle with
the recessed hub facing down. Slide both flat washers
onto the axle. Slide the other wheel onto the axle with the
recessed hub facing up. Install the other E-clip.
10.3 MOUNT THE AXLE TO THE CHARGER: Place one end
of each axle bracket into the slot on the bottom of the
charger. Separate the wheels and flat washers on the
axle so that there is one wheel and one flat washer on
each end of the axle assembly. Place the axle assembly
under each axle bracket. Attach the axle brackets, using
the two #10-32 thread-cutting screws provided.
EEBC100A-Z
10.4 ATTACH THE HANDLE ASSEMBLY:
Turn the charger right side up onto its foot and wheels.
Attach the handle assembly using four #10-32 thread-
cutting screws provided.
NOTE: To retract or extend the handle assembly, push
in the button on the top of the handle.
8
• •