Using A Remote Antenna; About Satellite Signals; Calibrating The Screen; Battery Information - Garmin Mopar Navus 2 Manual De Instrucciones

a
PPendIx

Using a Remote Antenna

E
You can use an optional external remote
N
antenna (GA 27C). To purchase, go to
the Garmin Web site at
.com/products/Navus2, and click the
Accessories
Remove the weather cap from the
antenna connector located on the left of
the Navus 2, and connect the antenna.

About Satellite Signals

Your Navus 2 must acquire satellite
signals to operate. If you are indoors,
near tall buildings or trees, or in a
parking garage, the Navus 2 cannot
acquire satellites. Go outside to an area
free from tall obstructions to use your
Navus 2. When the Navus 2 has acquired
satellite signals, the signal strength bars
on the Menu page are green
When it loses satellite signals, the bars
turn red or disappear
information about GPS, visit
www.garmin.com/aboutGPS.
22
www.garmin
link.
. For more

Calibrating the Screen

If the touch screen is not responding
properly, calibrate the touch screen. Turn
the unit off. Press and hold the
button for about one minute until the
Calibration screen appears. Follow the
on-screen instructions.

Battery Information

Your unit contains an internal (non-
removable) lithium-ion battery. The
battery should last up to 8 hours,
depending on usage.
The
the Menu page indicates the status of the
internal battery. If the icon is not present,
the Navus 2 is connected to external
power.
Contact your local waste disposal
.
department for information on properly
disposing of the unit.
battery icon in the corner of
Navus 2 Owner's Manual
Power