Maintenance Instructions; Cables; Autofeed; Cleaning - Rigid Auto-Clean K-30 Manual De Instrucciones

from the drain by hand and feed into the drain cleaner. If
needed, continue cleaning following the above process.
Several passes through a line are recommended for
complete cleaning.

Maintenance Instructions

WARNING
ON/OFF/REV switch should be OFF and machine un-
plugged before performing any maintenance.
Always wear safety glasses and leather work gloves
when performing any maintenance.

Cables

Cables should be thoroughly flushed with water after
every use to prevent damaging effects of sediment and
drain cleaning compounds. Flush cable with water and
drain debris from drum by tipping machine forward after
every use to remove sediment, etc. which can corrode
cable.

AUTOFEED

After each use, hose out AUTOFEED assembly with
water and lubricate with lightweight machine oil.

Cleaning

The machine should be cleaned as needed with hot,
soapy water and/or disinfectants. Do not allow water
to enter motor or other electrical components. Make
sure unit is completely dry before plugging in and using.

Replacing the Cable

1. Remove the guide hose by pulling it off of the nose of
the machine. Pull up on the AUTOFEED levers so that
the end of the cable can fit through the AUTO FEED
and pull the cable through the guide hose. Push re-
maining cable back into the drum until just the tip of the
cable is left outside of the nose of the machine.
2. Loosen the three screws surrounding the outer drum
housing. (The screws do not need to be completely
removed). Remove the drum cover.
3. Pull the entire drum out of the machine.
4. Flip the drum over and remove the three outer-most
screws from the drum. (Figure 15)
5. Pull out the inner drum and disconnect the cable.
Push the end back into the drum.
6. Face the drum towards the floor. Starting with the
auger end of the cable, pull the cable out completely
through the front of the drum.
Auto-Clean™ Drain Cleaning Machine
Figure 15 – Removing Screws From Drum
7. Feed the end of the new cable back through the
nose of the outer drum and then attach it to the inner
drum (Figure 16) . Use the illustration on the inner
drum as a guide for which direction to start the cable.
Figure 16 – Attaching Cable To Inner Drum
8. Replace inner drum back in outer drum. Put the sec-
tion of the inner drum with the cable attached into the
outer drum first. Push the rest of the inner drum into
place. Line up the three screw holes and replace
the screws.
9. Flip the drum over and manually feed the cable back
into the drum. (Figure 17)
Clutch Retention Screw
Clutch Adjustment
Screw
Inner Drum
11