Whale AK1001B Instrucciones De Instalación página 6

AK1001B
AK1002B
6

Replace the white lid and connect the wires
with the brown/white wire to the positive
supply and the brown wire to the positive of
the pump (Fig 8).
12. Mk II INSTALLATION

Turn off and disconnect all power going to
the grey waste tank.

Disconnect the two wires going from the
float switch to the power source, pump or
electrical system in the boat.

The wires protruding from the screwed in
finger float switch which enters the tank
through the side can be snipped off (Fig
9). In order to maintain the watertight
integrity of the tank, DO NOT REMOVE
THE FLOAT SWITCH. The relay
mounted on the side of the tank becomes
obsolete.

Assemble the kit as described in the
Section 9.

Discard the old lid of the Grey Waste Tank
and screw the new assembly into place (Figs.
9 & 10).

Connect the wires of the float switch, with the
brown/white wire attached to the positive
supply, and the brown wire attached to the
positive of the pump.
Munster Simms Engineering Ltd., 2 Enterprise Road, Bangor, Co. Down, N. Ireland, BT19 7TA
GREY WASTE TANK
SERVICE KIT
Tel: +44 (0)28 9127 0531
Web:www.whalepumps.com Email: info@whalepumps.com
Fig. 8
Fig. 9
Fig. 10
Previous
Finger Float
Switch