Chain Mount - Textron GREENLEE Ultra Tugger 6800-22 Manual De Operación

Setup (cont'd)

Chain Mount

Requires: Exposed metallic conduit with the following
characteristics:
• 63.5 mm to 254 mm (2-1/2" to 10") in diameter
• capable of withstanding at least 35.6 kN (8000 lb) of
force
Do not mount the pipe adapter to the
following:
• steel conduit less than 63.5 mm
(2-1/2") in diameter
• PVC conduit of any size
These conduits will not support the
loads imposed by the puller.
Failure to observe this warning can
result in severe injury or death.
NO
When setting up the pipe adapter, do
not use the vise chains on a structural
support that is less than 51 mm (2")
or more than 254 mm (10") wide. An
oversized or undersized structural
NO
support can allow the puller to slide
or break loose and strike nearby
personnel.
Failure to observe this warning can
result in severe injury or death.
Install the vise chains properly.
• Follow the vise chain tightening instructions care-
fully. Improperly tightened chains can allow the
puller to slide or break loose and strike nearby
personnel.
• Do not allow the vise chains to bind at the corners
when mounting the puller to a square or rectangular
support. The vise chain must be uniformly tight at
all points.
Failure to observe this warning can result in severe
injury or death.
Greenlee / A Textron Company
6800-22 Ultra Tugger
37
Cable Puller and Pulling Package
®
Do not pull between the 10 o'clock and 2 o'clock
directions. Pulling between 10 o'clock and 2 o'clock
can damage the mounting conduit.
11
PULLING
10
ROPE
PULL
LOAD
9
VISE CHAINS
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
12
O'CLOCK
1
TAILING
ROPE
2
SUPPORT
6
O'CLOCK
3