Palazzetti EASY TOUCH Uso Y Funciones página 18

2.3.2
Display brightness when in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set the desired brightness (
2.3.3
The data shown on the display when this is in standby mode can be set.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"OFF"
"1"
"2"
"3"
e) Press to con rm the settings.
2.3.4
The volume of the buzzer can be set based on requirements:
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu [
d) Set the desired volume (OFF, 1 to 5) using the
2.3.5
A good combustion depends on several factors (type of installation, operation and maintenance conditions, type
of pellet etc ..)
If at the end of combustion in the brazier are many waste, it is advisable to change the combustion con gurations
(increasing the value) to nd the most satisfactory solution.
a) Use the arrow buttons
b) Use the button to select the password "7" and then press
c) Use the button to scroll to and select submenu
d) Set one of the following values using the
"1"
"2"
"3"
e) Press to con rm the settings.
18
to go to the setup menu
OFF, 1 ... 5
to go to the setup menu
The display remains on the last operation set by the user;
All operating parameters are displayed cyclically;
The room probe temperature is shown
The current time is shown
to go to the setup menu
to go to the setup menu
and then press
[11]
and press
) using the buttons and press
and then press
[12]
and press
and buttons:
and then press
13
] and press
buttons and press
and then press
[14]
and press
and buttons:
;
to con rm;
to con rm;
to con rm.
;
to con rm;
to con rm;
;
to con rm;
to con rm;
to con rm.
;
to con rm;
to con rm;