Palazzetti EASY TOUCH Uso Y Funciones página 19

3
3.1
Before every ignition, be sure that burning pot is completely empty and properly positioned in its seat.
To start the stove hold the
The ame icon will start ashing during the ignition stage until remaining on steady when the stove has started.
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
traditional re lighters.
Avoid lighting the ame manually if the stove's automatic ignition system is not working correctly.
When the stove is started the rst time, unpleasant odours or smoke may be generated, caused by evaporation
or drying of certain materials used. This phenomenon will gradually disappear.
The room should be well ventilated when starting the stove the rst few times.
"S "
EALED SERIES STOVES
3.2 MODIFYING THE PARAMETERS
The stove operating parameters can be modi ed as described.
The values set will be retained until next modi ed, even when the stove is switched off or unplugged from the
power supply.
3.3 SWITCHING OFF
To switch the stove off hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched off following the procedure described above. Never switch the stove off by
unplugging it from the power supply.
3.4
The stove can be switched on/off manually or in programmed mode.
The stove modulates output according to the room temperature read by the probe on the stove (that is, the stove
attempts to maintain the desired temperature while minimising fuel consumption).
set.
The desired room temperature can be set in the temperature menu
button for several seconds.
button for a few seconds; the ame icon will switch off.
.
19