Changing The Illumination Lamp; Cleaning And Care - Beko RCNA355E31PT Manual De Instrucciones

EN

Changing the illumination lamp

To change the lamp used for illumination of
your refrigerator, please call your Authorized
Service.
The lamp(s) used in this appliance is not
suitable for household room illumination. The
intended purpose of this lamp is to assist the
user to place foodstuffs in the
refrigerator/freezer in a safe and comfortable
way.
The lamps used in this appliance have to
withstand extreme physical conditions such as
temperatures below -20°C.

Cleaning and care

Interior and Exterior Surfaces
Attention
Always unplug the power cable or switch
off the circuit breaker before cleaning.
Clean the exterior using lukewarm water and a
mild detergent.
Never use detergents, abrasive or acidic agents.
Wipe the inside compartment dry.
Be careful to prevent water from getting into
contact with the electrical connections of the
temperature control or the interior light.
If the device is not going to be used for a
long period of time, unplug the power cable and
remove all food. Clean the appliance and keep the
door open.
To preserve the appearance of your appliance,
you can polish the exterior and the door
accessories with a silicone wax.
Clean the condenser at the back of the appliance
once a year using a brush or a vacuum cleaner.
Dust build-up leads to increased energy
consumption.
Inspect the door gasket at regular intervals.
Clean with water only, and wipe totally dry.
Cleaning of the accessories
Door shelves:
Remove all food from the door shelves.
Lift the cover of the shelf upwards and pull it off
sideward.
Remove the bottom of the door shelf by pushing it
upwards.
Collecting container (Pan):
Make sure that the pan at the back of the
appliance is always clean.
Gently release the snap of the pan from the
compressor by pushing it using a tool (like
screwdriver), so that the pan can be removed.
Lift the pan, clean it and wipe it dry.
Re-assemble in reverse order.
Crisper or Drawers:
To clean a drawer, pull it out as far as possible, tilt
it upwards and then pull it out completely
(Item 7-8).
8
Instruction for use