Kwik Tek Sportstuff 58-1015 Manual De Uso página 4

MOUNTING PLATFORM CONNECTION: To connect the mounting platform to the main unit,
lace the supplied rope through each unit and tie a knot at each end as shown in the following
photos:
INFLATION: This product is equipped with the following types of valves:
Recessed Speed Valve - Secure the speed valve by firmly screwing the bottom
portion of the valve into the base. To inflate, unscrew only the cap (top portion) of
the valve. Using the hose from your inflator, inflate through the top opening of the
valve. When fully inflated, replace the cap by screwing it clockwise onto the bottom
portion of the valve. To deflate, unscrew the bottom portion of the valve from the
base in a counter-clockwise direction.
Speed Safety Valve: Pulls out for fast inflation/deflation, then can be pushed in
flush with the tube. Secure the valve by firmly fastening the bottom portion of the
valve into the base. To inflate, open cap or top portion of the valve. Using the hose
from your inflator, inflate through the top opening of the valve.
1) Begin by tying a knot around the right-most loop on the
main unit. Lace the rope through each loop, alternating
between a main unit loop and a mounting platform loop.
2) Continue lacing the rope through the loops, tightening
and closing the gap between the two units as you pro-
ceed.
3) Once the rope has been laced through all loops, tighten
rope and tie a knot around the last remaining
loop. As the unit is used, be sure to check the connection
and tighten as necessary
NOTICE: When initially unpacked, the recessed speed valve on this
item will have a protective ring within the recessed portion of the valve
base. Remove this protective ring before inflating and using the tram-
poline. The ring is only used to protect the valve during packaging and
shipping and serves no functional purpose once unpacked and in use.