F&P Icon Menu System; On/Off And Ramp; Humidity; Alarm On/Off - Fisher&Paykel ICON Manual De Uso Y Cuidado

2. F&P ICON MENU SYSTEM
Display Screen/Menu System
• The Home Screen is the default display where each part of the Menu System can be viewed and
represents the available settings. Once a selection has been made with the Menu System, the Display
Screen will dim and return to the Home Screen after 30 seconds.
• The lock symbol will appear if the Menu System is left idle for 10 minutes. To reactivate turn the
SmartDial a half turn in either direction (180°).
1
2
3

1. On/Off and Ramp

• When the selection circle is at the top of the Menu System a quick press
to the SmartDial will start therapy.
• To activate Ramp, press the SmartDial again and hold for
3 seconds. The Ramp symbol will appear
• To stop and start pressure delivery, press the SmartDial when the
selection circle is at the top point.

2. Humidity

• To control the level of humidity delivered to the mask, turn the SmartDial
to the Humidity setting . Press to enter and turn the SmartDial again to
select the desired humidity level from 0 (off ) to 7 (maximum). Press again
to accept the change. For example, if the air is feeling too cold increase
the Humidity setting in increments of 1 or 2 over 2 to 3 nights until you
find the level that is comfortable.
NOTE: The default setting is Humidity level 4. If using without water, set
the humidity level to zero. The humidity level cannot be adjusted if Flight
Mode is set to ON.
• The Boost control offers three additional levels to optimize the Humidity
setting. Press and hold the SmartDial for 3 seconds while in the Humidity
setting and the Boost symbols will appear. Turn to select low,
medium or high and press again to accept the change.
CAUTION: The Boost control should only be used in extreme situations
when experiencing symptoms from your CPAP therapy. The default Boost
setting (medium) will be suitable for most patients.

3. Alarm On/Off

• Turn the SmartDial to the Alarm setting , press to enter, then turn to
select either On or Off . Press again to accept the change.
• If Alarm On is chosen, turn the SmartDial to select either the default
bell or the music symbol for AlarmTunes™ , and press again to
accept the change.
• Press the SmartDial once to snooze the Alarm for 10 minutes, twice to turn
the Alarm off and a third time to discontinue therapy.
NOTE: The AlarmTunes symbol is only visible when the InfoUSB™ is
inserted. F&P Studio™ software is required to utilize the AlarmTunes
feature.
A - 4
.