Publicidad
Idiomas disponibles
Idiomas disponibles
7. FITTING THE MONITOR.-
Mod. H8705.
Bring the monitor (2) to the handlebar
stem (12) Fig.10, connect the two
terminals (15) and (Q), coming out of
the handlebar stem (12) and the
monitor (2), Fig.10.
Insert
the
monitor
handlebar stem (12), as shown in
Fig.10, making sure not to pinch any of
the cables. Fit the bolts (6) along with
the flat washers, making sure that the
handlebar is aligned correctly, securely
tighten all of the bolts on the handlebar
stem including the bolts at the base
which were left hand tight in point 4.
Mod. H871.
Bring the monitor (2) to the handlebar
stem (12) Fig.11, connect the two
terminals (107) and (Q), coming out of
the handlebar stem (12) and the
monitor (2), Fig.11.
Insert
the
monitor
handlebar stem (12), as shown in
Fig.11, making sure not to pinch any
of the cables. Fit the bolts (6) along
with the flat washers, making sure that
the handlebar is aligned correctly,
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
Mod. H872N.
Bring the monitor (2) to the handlebar
stem (12) Fig.12, connect the two
terminals (107) and (Q); (136) and (v)
coming out of the handlebar stem (12)
and the monitor (2), Fig.12.
Insert
the
monitor
handlebar stem (12), as shown in
Fig.12, making sure not to pinch any
of the cables. Fit the bolts (6) along
(2)
onto
the
(2)
onto
the
(2)
onto
the
with the flat washers, making sure that
the handlebar is aligned correctly,
securely tighten all of the bolts on the
handlebar stem including the bolts at
the base which were left hand tight in
point 4.
LEVELLING.-
Once the unit has been placed into its
fi nal position, make sure that it sits
flat on the floor and that it is level. This
is achieved by screwing the adjustable
foot (28) up or down, Fig.13.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (23)
to make it easier to move about. The
two wheels at the front of the unit
make it easier to place the unit in any
chosen position, as shown in the
Fig.14. Store it in a dry place,
preferably not subject to changes in
temperature.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
(106) into the connection hole (k) on
the main body (40) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Fig.15.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
17
and
then
plug
the
Publicidad
