Unpack Thepressure W Asher; Carton Contents - Craftsman 580.752211 Manual Del Operador

Your p ressure washer requires some assembly andisready
foruse onlyafter i thasbeen properly serviced withthe
recommended oiland fuel.
If
you have any problemswith the assembly of your
pressurewasher, please call the pressurewasher helpline
at 1=800-222-3136.
UNPACK THEPRESSURE W ASHER
1. Remove everything from carton except pressure washer.
2. Open carton completely by cutting each corner from top
to bottom.
3. Remove pressure washer from carton.
5. Add fuel to fuel tank and Fresh Start fuel cartridge to fuel
cap.
6. Connect pressure hose to spray gun and pump.
7. Connectwater supply to pump.
8. Attach nozzleextension to spray gun.
9. Select/attach quick connect PrecisionSpray
TM
nozzle to
nozzle extension.
Attach Handle and Accessory Tray
1. Place handle (A) onto handle supports (B) connected to
main unit. Make sure holes (6) in handle align with holes
(6) on handle supports.
CARTONCONTENTS
Check all contents, if any parts are missing or damaged, call
the pressure washer helpline at 1-888-222-3136.
• Main Unit
• Handle
• Accessory Tray
• High Pressure Hose
• Spray Gun
• Nozzle Extensionwith Quick Connect Fitting
• Oil Bottle
• Hose Wrap
• Safety Goggles
• Bottle Bracket Wireform (2)
• PerfectMix
TM
Siphoning Unit/Hose
• Fresh Start FuelCartridge
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 5 PrecisionSpray
TM
Nozzles
• HandleFasteningHardwareKit (which includes):
• Handle Bolts (2)
• Carriage Bolt (2)
• Plastic Knobs for Handle (2)
• Rope Guide (1)
• Plastic Knob (3)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration on
page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING PRESSURE WASHER
Your Craftsman pressure washer will need assembly before
operation:
1. Fill out and send in registration card.
2. Attach handle,accessory tray, rope guide and hose wrap.
3. Connect detergent siphon hose to pump.
4. Add oil to engine crankcase.
2. insert handle carriage bolts (D) through holes from
inside of unit and attach a plastic knob (E) from outside
of unit. Tighten by hand. By loosening both knobs to the
middle section of the attachment bolt, the upper handle
can fold forward to store fiat atop the cold engine.
NOTE:DONOT fold the handle down while the engine is hot.
.
Placeaccessory tray (F) over holes (6) on handle
(viewing from back of unit). Push the tree clips (H) into
the holes until they sit fiat against the accessory tray.
.
i
insert multi-colored PrecisionSpray
TM
nozzles and other
supplied accessories in spaces provided in accessory
tray. See How to Use Accessory Tray.